11/20/2022 0 Comments Hercules rmx and traktor pro![]() ![]() once loaded all your MIDI controls will do something) which can be found on the Hercules site here: Ĩ&pid=177&cid=5 (to load them go Preferences -> hotkeys & MIDI setup -> MIDI setup -> Load) Step 2: Now all of the functions might not do what they are supposed to do but it did fix the 'cue + headphone' issues for me and i'm now able to cue my tracks and hear them in the headphones etc. TKS file into traktor (which is a MIDI profile. Then, set - Output Channel A : Output 1/2 - Output Channel B : Output 3/4 This way, each deck will sent its signal to thei specific channels.ĭid you install the latest drivers available from the support site ? Ĩ&pid=215&cid=1 Installing the driver wont do any harm but what i recommend to anyone who is having this same issue (which i was having but have now resolved it 30 minutes ago) is: Step 1: Load the latest. This will change the way the channels are displayed. ![]() ![]() Could you be a little more specific about what exactly you are try to do, as people often get confuse when they refer to "external mixer" ? If you want to use the Rmx : - to control all the function of the software ( cross fader, EQ, FX, etc) - so the soundcard outputs both your main mix and headphone preview Then this would be called Internal mixing by Traktor, and your console should be configured as explained in the following document: If however you want to use the Rmx so that it controls some functions of the software BUT you want the soundcard to send Deck A and Deck signal to 2 distinct channels on to a mixing board that you would use to apply EQ, and connect your headphone, then you can basically follow the same procedure as mentioned before, but with this difference: When setting OUTPUT ROUTING, be sure to select EXTERNAL for MIXING MODE. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |